Semi Automatic PCB Cutting Machine Lead Wire Cutting PCB Foot Cutter Tool Board Circuit Foot Cutter 0.8mm - 2.5mm Thickness with a Blade

Parameters Base plate thickness: Approx 0.8mm - 2.5mm/0.03-0.1inch Lead wire cutting height: Appeox 1.5mm - 3mm/0.06-0.12inch Blades turning speed: 4500r/min Rail travel: 0 - 280mm/0-11.02inch Blade size: Φ200 x 70 x 3.5mm/Φ7.87*2.76*0.14inch Rated Power: 550W Power supply: AC110V, 50Hz Operation 1. Place the welded test plate on the adjusted wiping and cutting machine, and insert the guide rail along the guide rail lead-in line. 2. Push the right feed handle to push the plate forward at a constant speed 3. Repeat steps 1 and 2 to finish cutting the welding plate. Note: Avoid moving the sign too fast, which will directly shorten the service life of the blade and even endanger safety. Notice 1. The rotating parts need continuous lubrication. 2. Clean the cutting pin 3. If the transmission triangle belt is damaged, it needs to be replaced immediately 4. The blade should not leave the cutter head for too long. If the cutter head leaves for several days, lubricate the cutter head if necessary.Package Content #151026

• 【PCB Cutter】- PCB cutting machine is mainly used to cut off redundant pins after components are welded. The linear cutting machine can save the blade and prolong the service life of the machine.
• 【Material】- The shell is made of fine steel plate with a thickness of nearly 11mm. The whole circuit board cutter is stable, low jitter and low noise.
• 【Triangular Position】 - The three hole blade gland adopts the triangle positioning principle, and the blade is firmly fixed and not easy to loosen. Under high-speed conditions, the blades do not slip, operate stably and chamfer accurately.
• 【Speed】- Blade speed is fast, the jitter is small and the pin is cut smoothl. Blades turning speed is 4500r/min. The key parts are grinded, the imported bearings are assembled, and the chamfering consistency is good.
• 【Double Guide Rails】- The stroke of double guide rails is adjusted synchronously, and the cutting height is adjustable. Lead wire cutting height is about 1.5mm to 3mm. The stainless steel guide gland can be adjusted up and down freely, realizing the applicability of the base plates with different thicknesses.