Eaton 7ft Remote Control Cable

The Eaton REMOTE08-07 is a seven foot cable made for remote control connections. Each end carries a three pin connector that mates cleanly with compatible Eaton gear, including many EPDU models, so you can extend control signals without hunting for adapters. Once plugged in, the copper conductor moves data with minimal loss, helping your switches, panels, or monitoring hardware respond instantly.

This cable fits right into places where equipment sits a short distance from the operator. In a data center you can link a rack-mounted EPDU to a control console on the aisle. On a plant floor you can route a signal line from a machine enclosure to a protected control station without running extra conduit. Audio-visual technicians can keep a control surface at the front of house while the power equipment stays backstage. Wherever you need a tidy, reliable remote link, the REMOTE08-07 makes the job straightforward.

Installation is simple: seat the three pin connector, tighten any retention screws on the host device, and power up. The cable’s jacket resists everyday abrasion and flexing, so once it is in place you can expect long service life with little maintenance. For new builds, upgrades, or quick replacements, this Eaton cable delivers solid performance without extra fuss.

• Seven foot length provides convenient reach between control points
• Three pin connector on each end simplifies direct plug-in to compatible Eaton devices
• Copper conductor supports efficient, low-loss signal transmission
• Built for remote control applications in data centers, industrial sites, and AV setups
• Compatible with Eaton EPDU units and other supported equipment